hair dryer thermal fuse; what temperature?

what is the typical cutoff temperature of the thermal fuse inside a hair
dryer?

the label on it has been partially burned off and is unreadable


http://www.comstatinc.com/thermalcutoffs.cfm


I guess the fuse blew because I used it inside my blankets (to quickly warm
the bed).


.

Relevant Pages

  • Re: Electric dryer - thermal fuse question
    ... Our Sears electric dryer went completely dead about 2 seconds after pressing the "push to start" button. ... I've located a 196 degree thermal fuse in-line to the motor that could be responsible for complete power loss to everything 120v if it's gone bad. ... With both leads disconnected I'm getting a reading on that thermal fuse that flips between .5 and .6 ohms. ...
    (sci.electronics.repair)
  • Re: Electric dryer - thermal fuse question
    ... Our Sears electric dryer went completely dead about 2 seconds after pressing the "push to start" button. ... I've located a 196 degree thermal fuse in-line to the motor that could be responsible for complete power loss to everything 120v if it's gone bad. ... With both leads disconnected I'm getting a reading on that thermal fuse that flips between .5 and .6 ohms. ...
    (sci.electronics.repair)
  • Re: Electric dryer - thermal fuse question
    ... fuse that flips between .5 and .6 ohms. ... paltry .5 ohm reading enough to indicate that a thermal fuse is bad? ... not looking to start or run the dryer with the thermal fuse bypassed. ... The way I'm reading the wiring diagram for this model - a Sears ...
    (sci.electronics.repair)
  • Re: Electric dryer - thermal fuse question
    ... I've located a 196 degree thermal fuse in-line to the motor that could ... not looking to start or run the dryer with the thermal fuse bypassed. ... The way I'm reading the wiring diagram for this model - a Sears Ken"less ... ignored unless my full name AND either lasers or electronics is included in the ...
    (sci.electronics.repair)
  • Re: Electric dryer - thermal fuse question
    ... I've located a 196 degree thermal fuse in-line to the motor that could ... To my knowledge I should be reading zero ohms if the fuse is good. ... not looking to start or run the dryer with the thermal fuse bypassed. ... The way I'm reading the wiring diagram for this model - a Sears Ken"less ...
    (sci.electronics.repair)