Re: Sony TV model KV-24FV10 set from hell

On Wed, 29 Aug 2007 15:26:40 -0700, "captainvideo462002@xxxxxxxxx"
<captainvideo462002@xxxxxxxxx> wrote:



I got this set in after a storm. There was a black flash burn on the
board across the AC line terminals. When turn on is attempted the
relay clicks about twice every second. I have checked just about every
component on the power supply board. I have replaced the following
components, (Some of which didn't seem bad when comparing them to new
replacements with an ohm meter) but I replaced them anyway:
IC602, (SE135)
R648, (2.2K)
D606, (TF541M)
PH600, (PC123)
IC601, (STRF6626)
I've had this pig almost two months now so it is a total loss as far
as trying to make any money on it but I would at least like to try to
get my parts value out of it and maybe preserve a little dignity. I'm
not really sure how to troubleshoot this clicking relay symptom. Did
I miss something? Can any one help me with any ideas and perhaps a
schematic? Thanks for any assistance with this. Lenny Stein, Barlen
Electronics.


Try putting a jumper across the relay. This will at least allow you
to see what the set does when it's forced on.
Andy Cuffe

acuffe@xxxxxxxxx
.

Relevant Pages

  • Sony TV model KV-24FV10 set from hell
    ... There was a black flash burn on the ... board across the AC line terminals. ... replacements with an ohm meter) but I replaced them anyway: ... not really sure how to troubleshoot this clicking relay symptom. ...
    (sci.electronics.repair)
  • Re: Landcruiser fuel injection relay problem
    ... obvious corrosion but one of the 4 terminal ends is somewhat ... socket holes look fine and the same. ... This relay is in an enclosed box ... In any event I treated all the terminals and the socket with A-120 ...
    (alt.autos.toyota)
  • Re: Landcruiser fuel injection relay problem
    ... socket holes look fine and the same. ... This relay is in an enclosed box ... In any event I treated all the terminals and the socket with A-120 ... Corrosion Free. ...
    (alt.autos.toyota)
  • Re: Sony TV model KV-24FV10 set from hell
    ... component on the power supply board. ... replacements with an ohm meter) but I replaced them anyway: ... not really sure how to troubleshoot this clicking relay symptom. ...
    (sci.electronics.repair)
  • Re: Selenium rectifier question
    ... plate voltage, the main power fuse F1 blows. ... I'd disconnect the relay and comfortably check all other ... There is no pin on the device at #2, but the two wires from the relay ... internet that had exact replacements for the '1N1239' Sarkes Tarzian ...
    (sci.electronics.repair)