Mitsubishi M1GA no green



It's been a few years of a good TV after I replaced almost all the
caps in this set, now it has a new issue. On all video (DVD, tuner
etc.) again it seemed like it had AGC issues. This time though, when
the picture went to a brite scene it would get washed out and brite
then return to normal. This was a bit irritating but I could live with
it. Another issue occured only on the upper cable channels (60+) where
it would start showing horiz slashes that would stack up in a diagonal
pattern. They would keep increasing until it reached a point where it
would lose sync turn black and make a hideous buzzing sound in the
audio. This could last several seconds then it will snap back and lock
and everything would be fine again. I don't know that these issues are
related but last night after the buzz when the picture came back, it
seems as if I lost the green gun and now I have a magenta picture. The
tube may be shot (it certainly is old enough) but I'm not in a
position to get a new one. If this sounds like anything familiar let
me know. I'm going to look at the caps on the neck (about the only
ones I haven't changed) but that's about all the mojo I have. If you
can help, tia.
.



Relevant Pages

  • Re: vertical jitters
    ... From time to time, the picture gets ... Then it gives one big jump and then it's okay ... PSUs faulty caps often run hot while smaller caps in signal stages were ...
    (sci.electronics.repair)
  • Re: Mitsubishi M1GA no green
    ... related but last night after the buzz when the picture came back, ... seems as if I lost the green gun and now I have a magenta picture. ... I'm going to look at the caps on the neck (about the only ... joint on the neck circuit. ...
    (sci.electronics.repair)
  • Re: Toshiba TV problem?
    ... It started after a local power ... just change the caps near the frame /vertical IC. ... I've read say to just short out the caps and picture tube. ... use a high wattage (not for power but to hold off the high ...
    (sci.electronics.repair)
  • Re: Sony PVM-1954Q retrace issue
    ... it's there if you move the picture with the vertical centering. ... All other alignments appear to work correctly. ... you went WAY overboard on the caps thing. ... Your 'retrace' lines are not retrace lines. ...
    (sci.electronics.repair)

Quantcast