Re: Repair ATX power supply

Long time ago I wrote the following scheme:

Further to my prev message, I tried testing power transistors on diode
setting, and nomatter what combination of pins/tab I connect to, it always
reads zero volts..

Chris


.

Relevant Pages

  • Re: A QUICK CHECK OF YOUR GALVANIC ISOLATOR.
    ... in over 20 years working on boats I've never encountered a boat ... in the water on shore power that had zero volts across the Galvanic ... So a reading of zero is a fairly good indication that either the GI is ...
    (rec.boats.electronics)
  • Re: Im Busted for shoplifting
    ... DC doesn't pass through zero. ... When describing the most simple characteristics of a transformer, ... you had applied an AC voltage, ... horizontal trace line represents zero volts, ...
    (rec.crafts.metalworking)
  • Re: Mythbusters: V/I ratio is forced to Z0
    ... how else could you read zero reflected power at that point if it didn't establish that environment? ... is sampled as 10 volts. ... Subtracting them will result in zero volts. ... No 50 ohm environment required. ...
    (rec.radio.amateur.antenna)
  • Re: Op Amp - Design question
    ... >I need to reject the DC component and amp the 20 mVolts to 0-5 Volts. ... sensor's output should be zero. ... If your desired signal (measured parameter) is intrinsically AC with a ... longer term average of 0, then you could use a longer-term average ...
    (sci.electronics.design)
  • Re: maximum power to load?
    ... > V=IR, hence if R is zero, V is zero. ... This conclusively proves that a resistor of zero ohms has a resistance of N ... volts, where N is the source voltage. ... the source voltage (provided the source resistance is equal to the supply ...
    (sci.electronics.misc)