Re: CRT Puzzler, strange behavior, help needed
- From: PeterD <peter2@xxxxxxxxxx>
- Date: Tue, 26 Feb 2008 08:58:17 -0500
On Mon, 25 Feb 2008 21:20:10 -0800 (PST), wndrful <wndrful@xxxxxxxxx>
wrote:
On Feb 25, 5:18 pm, "mc" <l...@xxxxxxxxxxxxxxxxxxxxxxxxxx> wrote:
I think your computer is set to a scan speed that the monitor doesn't
support very well. The monitor apparently can produce a picture, but
doesn't recognize it as valid input -- except during the moments when the
computer is turning on and goes into plain VGA mode for a moment.
Right-click on your Windows desktop, go to Properties, Settings, Advanced,
Monitor, and change the refresh rate.
Hmm... it is the other way around. After I wait a second and connect,
then monitor comes on and is able to display at higher refresh rates.
I believe I was running it at 1400x1050 at 70Hz and it runs fine at
that refresh rate.
It doesnt work if it is connected right from the beginning
Also, resolutions supported by this monitor:
1024 x 768
1152 x 870
1280 x 1024
1600 x 1200
1792 x 1344
1800 x 1440
1856 x 1392
1920 x 1440
No where in that list do I see 1400x1050. Again, set to a resolution
that the monitor supports and it probably will work properly.
.
- Follow-Ups:
- References:
- CRT Puzzler, strange behavior, help needed
- From: wndrful
- Re: CRT Puzzler, strange behavior, help needed
- From: mc
- Re: CRT Puzzler, strange behavior, help needed
- From: wndrful
- CRT Puzzler, strange behavior, help needed
- Prev by Date: Re: CRT Puzzler, strange behavior, help needed
- Next by Date: For UK readers - in Aldi this week
- Previous by thread: Re: CRT Puzzler, strange behavior, help needed
- Next by thread: Re: CRT Puzzler, strange behavior, help needed
- Index(es):
Relevant Pages
|
