Re: LG Tromm Washer WM2077CW Service Manual - Link

On Tue, 26 Feb 2008 15:53:03 -0500, "Michael Kennedy"
<Mikek400@xxxxxxxxxxxxxxxxxxx> wrote:

I have LG Tromm WM2077CW and I am looking for the schematics. It has barely
been used, but is out of warranty. Here is the problem it has had since day
1. If you run a load of laundry it takes almost 2 hours to finish. It tries
and tries to balance the load until it gets it right. Well I don't care if
it is balanced or not when it is in the spin cycle. I just want it to finsih
fast. So I want to look over the schematics and see if there is an easy way
to disable the balance sensor. Any Ideas?

TIA
Mike


http://www.justmanuals.com/washing-machine-wm2277h-wm2077cw-wm2177h-wm2677hm-wd11270bd-parts-service-p-17399.html

$9.99 and instant download

.

Relevant Pages

  • Re: ARC VT100 repair and test.
    ... perfect balance and everything was within tolerance. ... There was virtually no 2H in the distortion spectra once I de-bugged the amp, ... It isn't UL, strictly, because some of the load is distributed to ... An R69S BMW would have been a far better bike than a bloomin squaffer. ...
    (rec.audio.tubes)
  • Re: ARC VT100 repair and test.
    ... perfect balance and everything was within tolerance. ... There was no great matching of the 6DJ8 used in the amp during the tests I ... It isn't UL, strictly, because some of the load is distributed to ... The use of 8ohms connected across the 4 ohm outlets improves the load match ...
    (rec.audio.tubes)
  • Re: VST and Sched Load Balance
    ... > I am looking at the recent changes in load balance and I see that load ... wake to idle, etc etc. ... it can see non-zero load for the idle cpu. ...
    (Linux-Kernel)
  • Re: ARC VT100 repair and test.
    ... perfect balance and everything was within tolerance. ... There was no great matching of the 6DJ8 used in the amp during the tests I ... There was virtually no 2H in the distortion spectra once I de-bugged the amp, ... It isn't UL, strictly, because some of the load is distributed to ...
    (rec.audio.tubes)
  • Re: 6BX7 amp
    ... > Its usually hard to make a triode amp that sounds poor, ... recheck the balance but did not. ... But if you have a capacitor load of say 0.22 uF, and no other load, ...
    (rec.audio.tubes)