Re: Sony KV-35S45 Power Supply

I strongly suggest to use an original part. Sometimes the specs in the
service manual show a device like a simple transistor type, and it may
be using Darlington pairs or something like that.

--

JANA
_____


"packrat79" <zappyman@xxxxxxxxxxx> wrote in message
news:c89b0805-813d-4348-9f84-0679c67893e2@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I acquired this set with a blown HOT and power supply, and
presumably a bad flyback as well. I replaced the flyback, HOT, and a
number of power supply components including the MX0841 IC. Wouldn't
you know it, I had missed a shorted zener in the power supply, and of
course blew the brand new switching IC. Since I didn't have another IC
in stock, and it appears to be nothing more than two switching
transistors in one package, I tried replacing them with a pair of
normal switching transistors, similar to those used in other Sony
power supplies. This was of course after removing the shorted zener
diode from the secondary side. The power supply now starts but the
voltages are very low. There are three supplies on the secondary side
of this switching transformer (a separate xfrmr & circuit is used for
the 5V standby); the B+, which measures at just 50V, a 12V supply
which measures at 3V, and a 9V supply which is at zero. Removing the
12 and 9 volt rectifiers brought the B+ up to about 100V, but the
power supply makes a noticeable squeal and sounds like it's either
straining itself or not running hard enough (the switching transistors
don't seem to be getting warm though).
I've gone through the power supply and can't find any bad resistors
or diodes, which leaves me with just one question: is the problem
related to my subbing the MX0841 IC, or is there something else wrong
with this power supply? This is a difficult circuit to troubleshoot
and I'm just afraid there might be something more serious at fault.
Thanks for any help.


.

Relevant Pages

  • Re: To maintain CMRR (common mode rejection ratio) of op amp
    ... The diode i placed could be a zener diode. ... it and i jsut want to see the effect of the circuit focussing on CMRR ... this ckt two transistors are added to the input terminals of the op amp ... In PSPICE i tried to see the effect of common mode voltage ...
    (sci.electronics.design)
  • Re: What is the state of Robotics Currently.
    ... estimate the amount of computing power to duplicate human intelligence ... We don't need to simulate transistors to create a computer, ... with neurons switching at 1000 times per second and 100 ... Large parts of the brain is filled with interconnects (white ...
    (comp.robotics.misc)
  • Re: Using transistors as SPDT switch?
    ... I would like to build the switch in the following circuit using small signal ...
    (sci.electronics.design)
  • Re: Aiwa schematics ... ?
    ... Has anyone got schematics for an Aiwa MX-Z9500MK that they could either ... I don't really know why they bother switching the ... Anyway, having found these transistors, I went ... filament volts, and display on the amp, but still no filament volts up the ...
    (sci.electronics.repair)
  • Re: Diode reverse protection and current limiting.
    ... another SCR across it with a capacitor in series. ... A more modern design might have transistors cycling on and off to control ... If you are thinking of any kind of switching regulator, ...
    (sci.electronics.design)