Re: Selenium rectifier question

David wrote:

One note on voltage drop of selenium rectifiers: Rectifiers
were constructed by placing a set of plates is series. The
size of the plate determined the current rating. A new
rectifier had about 1.5 volts drop per plate at rated
current. Each plate could withstand about 45 to 50 reverse
volts. Most designs pushed the reverse voltage right to the
limit. As the device aged, the forward drop would increase,
power dissipation would rise, and the stack would eventually
fail with a very obnoxious smell.

I would have guessed pushing the current to the limit was more
dangerous (at the same power dissipation). The common
radio set with up to 100 mA seems to have been a safe haven
for seleniums as long as the electrolytic caps in the power supply
held or the fuse blew early enough?

Regards.
H.


.

Relevant Pages

  • Re: 6SN7 amp trouble?
    ... volts on your voltmeter, starting at the first ... plate and working in to second grid, ... Or just get a scope... ... Might be a little more careful and get trannys that are guitar amp ...
    (alt.guitar.amps)
  • Re: 6SN7 amp trouble?
    ... volts on your voltmeter, starting at the first ... plate and working in to second grid, ... Or just get a scope... ...
    (alt.guitar.amps)
  • Testing Tubes
    ... have been varying the control grid voltage from -2 volts to -3 volts while ... to the curves for pate current vs. control grid volts I should be getting 10 ... volts plate voltage with -2.5 volts at control grid. ...
    (rec.audio.tubes)
  • Re: More on PEP, AM, average power, etc.
    ... > saturation, the more linear does the plate modulation become. ... The plate current operating angle is small. ... Ideally it should be zero volts. ...
    (rec.radio.amateur.boatanchors)
  • Re: 6SN7 amp trouble?
    ... volts on your voltmeter, starting at the first ... plate and working in to second grid, ...
    (alt.guitar.amps)
Loading