Re: O.T. Step Potential ...

"N_Cook" <diverse@xxxxxxxxx> wrote in
news:fu1st2$i9g$1@xxxxxxxxxxxxxxxxxxxxxxxxx:

Arfa Daily <arfa.daily@xxxxxxxxxxxx> wrote in message
news:epSMj.354$DQ3.262@xxxxxxxxxxxxxxxxxxxxxxx
Sorry all. O.T. as a repair issue. Just something I read about today
that
I'm not sure I understand.

Anybody come across the term "step potential" or its effect in regard
to a downed live power line in contact with the ground ?

Arfa



Hollywood versions show the severed end of the cable, in intermittant
contact with the ground, snaking about like an unsupported hosepipe
issuing a water jet, - true, I don't know ?

Seen it. I was at a gas station north of LSU one day when linemen were
working to straighten a power pole.
They were tightening a guy wire when the winch slipped.

The pole snapped back to 'relaxed position' (about a 3 degree lean) and the
impulse traveled down the power lines.

The power lines started swinging to-and-fro. The linemen ran. I didn't know
why.

The wires touched on a swing and arced. Bzzzzzt. A loud, rough, 60 Hz
note.

The arc cut the wire.
The hot wire dropped onto the pavement and started jumping around, sparking
and buzzing at each contact.

I am standing about 50 feet away, putting gas in my car.
Cars on the street are slamming on their brakes and dodging the hot wire.

Finally, the circuit breaker tripped, killing the power.

THEN I had time to be scared.

I suspect the jumping is due to the magnetic field caused by the current
flow.
One section of the wire attracts or repels another, nearby section of the
same wire.



--
bz 73 de N5BZ k

please pardon my infinite ignorance, the set-of-things-I-do-not-know is an
infinite set.

bz+ser@xxxxxxxxxxxxxxxxxxxx remove ch100-5 to avoid spam trap
.

Relevant Pages

  • Re: A little help. Please
    ... I have been asked to install 12v recording equipment and 12v mini cam in a Taxi, What I need help on is, I know nothing about car electrics, how would I get power to this system without discharging the batter or messing the cars brain up when I disconnect the power to connect the system? ... I'd run a relay off the switched feed for the radio to power the CCTV system and so that the CCTV cuts off and draws no power when the ignition is off, and wire everything with non insulated crimp terminals, using a proper crimp tool. ... I would expect as a CCTV engineer you will already have a basic understanding of wiring and electronics. ... A car shouldn't present any unusual problems compared with any other DC system, barring vibration and the potential for wires to repeatedly flex / chafe. ...
    (uk.rec.cars.maintenance)
  • Re: Follow up to Mustang Airbag Light
    ... Getting it out, looking over the grey connector, looking for ... details on this infamous Tan/Red wire and working off some ... but code 12 indicates no power to the air bag firing circuit. ... I had the same problem on my '93 a while back (original owner, had car ...
    (rec.autos.makers.ford.mustang)
  • Re: Should I PID my Heat Exchanger?
    ... how did you bring power into the PID (a separate line ... I stole the power off the rotary power switch which is ... 16 gauge unstranded copper wire for the power to the controller and the ...
    (alt.coffee)
  • Re: How to PostMortem?
    ... > well they perform for each type of surge. ... "American Power Conversion's Equipment Protection Policy: ... one uses a #12 guage wire less than 5 ...
    (comp.os.linux.setup)
  • Re: Vista x64 BSODs
    ... The neutral and safety ground wires are usually tied together at the breaker ... Older homes may have a safety ground wire in the branch circuits that ... Don't rule out the power supply. ... Just get another 10' rod at Home Depot, ...
    (microsoft.public.windows.vista.hardware_devices)
Loading