Re: Toshiba vertical IC caps?



I've been looking at caps at various web pages and am going cross-eyed.
What's up with the different color of these caps in question? Is it just a
certain brand using a different color? To replace caps, is there anything
to know other than match the "uf" and the voltage ... and of course,
install them with the polarity correct? I thought I read somewhere about
being able to go, somewhat, "over size" with the voltage ... or did I
dream that?


The color is arbitrary, depends on the brand, manufacturing line, date, etc,
it's just coincidence that most of the caps in the vertical area are
reddish.

You want to match the uF rating, voltage can go higher, but I would try to
keep it within 200% of the original rating, if you go too high the ESR tends
to rise as well. Even the uF rating is often not critical at all, but don't
substitute that unless you know what you're doing.


.

Relevant Pages

  • Re: Toshiba vertical IC caps?
    ... What's up with the different color of these caps in question? ... anything to know other than match the "uf" and the voltage ... ... The color is arbitrary, depends on the brand, manufacturing line, date, ... to keep it within 200% of the original rating, if you go too high the ESR ...
    (sci.electronics.repair)
  • Re: Toshiba vertical IC caps?
    ... What's up with the different color of these caps in question? ... anything to know other than match the "uf" and the voltage ... ... The color is arbitrary, depends on the brand, manufacturing line, date, ... You want to match the uF rating, voltage can go higher, but I would try to ...
    (sci.electronics.repair)
  • Re: Tech:Capacitor failures (C20 and C21)?
    ... The higher the voltage ... rating the better. ... Do not exceed 15K on the caps. ... some spare TDA3020A amps and TL084CN chips laying around. ...
    (rec.games.pinball)
  • Re: capacitor value
    ... unless you need a capacitor to ... approach either its ripple current rating or its case temperature ... I usually choose electrolytic caps rated one or two ranges ... voltage, ...
    (sci.electronics.basics)
  • Re: IR2110 gate driver issues.
    ... I've been testing @ line voltage. ... input volts (I'm supplying the board via a variac and isolating transfomer for development). ... across the lower switch (and, of course, the diode). ... gatedrive 100nF rectangular blue plastic film caps to cheap ceramic ones ...
    (sci.electronics.design)
Loading