Re: Function of component in flash tube trigger circuit?

James Sweet <jamessweet@xxxxxxxxxxx> wrote in message
news:ArnRj.637$PY5.15@xxxxxxxxxxx



What seems strange is this transformer must be half or third of the
volume
of the ones in compact camera flashes but the tube is perhaps 100x the
volume of the tube in one of those cameras (1cm diameter, 20cm long).
Don't
know the joules rating of this one, a large studio flash unit, but 530V
standing voltage. Perhaps 2m of wire wrapped around the flash tube, as
trigger, all in all seems inadequtely tiny in comparison.

I think I'll try 2 camera ones in series with 100 ohms initially to try
and
localise why not triggering. I may try subbing this tiny stepup
transformer
with one 3 times the size from a compact camera, as am wondering if it
could
be internally arcing actoss turns.



The size is virtually irrelevant, as Sam says, almost no current is
required. I've used a tiny trigger transformer salvaged from a disposable
camera to trigger a huge (about 8" long) 1KJ flash tube. Some are bigger,
some are smaller, it has more to do with age, manufacturing process, and
the
need for compactness.



Is it possible to have a non-functional tube with no signs of problems ,
like the black patches on the ends of a fluourescent tube that is on the way
out.

This one looks perfect other than the glass is a bit dirty on the outside,
because the distributed trigger stops any cleaning. Not been dropped, no
cracked glass, no odd looking deposits on the elctrodes or on the inside of
the glass.


--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/




.

Relevant Pages

  • Re: Function of component in flash tube trigger circuit?
    ... What seems strange is this transformer must be half or third of the ... Is it possible to have a non-functional tube with no signs of problems, ... This one looks perfect other than the glass is a bit dirty on the ... by applying voltage to the tube and using a piezo flame igniter to trigger ...
    (sci.electronics.repair)
  • Re: Function of component in flash tube trigger circuit?
    ... What seems strange is this transformer must be half or third of the ... volume of the tube in one of those cameras ... I think I'll try 2 camera ones in series with 100 ohms initially to try ... I've used a tiny trigger transformer salvaged from a disposable ...
    (sci.electronics.repair)
  • Re: Function of component in flash tube trigger circuit?
    ... What seems strange is this transformer must be half or third of the volume ... of the ones in compact camera flashes but the tube is perhaps 100x the ... volume of the tube in one of those cameras ... I've used a tiny trigger transformer salvaged from a disposable ...
    (sci.electronics.repair)
  • Re: general question about audio amplifiers
    ... >> range of a tube amp, the output transformer is usually going to ... >> smooth out the content that a high fidelity amplifier would have ... >> The transient response, on the other hand, deals with the behavior ... >> of the transformer when subjected to complex input signals and is ...
    (sci.electronics.basics)
  • Re: 71A amp
    ... And if one tube begins to conduct more Iadc than the other as it ages, ... I like this the best because its simple, and bias ... Raymond Koonce wrote in message ... push-pull design with transformer coupled 56s driving the 71As. ...
    (rec.audio.tubes)