Re: Intermittent fault in Eizo 19" T766 CRT

On Tuesday 29 April 2008 04:06, Sjouke Burry wrote:

As a last(distasteful)resort you could discharge a cap
(~1000mfd 10-50volt)between pins with an intermittent
short in the blue gun.

I've decided not to try this. It's dangerous as it is, but especially for
heater-cathode shorts, because you often also blow out the filament.
.

Relevant Pages

  • Re: Free Centipede Board...
    ... shorting some traces or pins together. ... Try washing it ... and drying it. ... perhaps one pin is folded over and is making intermittent contact with ...
    (rec.games.video.arcade.collecting)
  • Re: IPC wiring harness connector for 1988 Toronado?
    ... working units and had the same intermittent issue. ... The sockets and pins on the connectors have a small tab on the back of them usually that can be pushed in with a needle mini screwdriver or a special tool, usually really expensive, so they can be pulled out. ...
    (rec.autos.tech)
  • Re: Toshiba tube shorted. Can I clear it?
    ... >>pins are the pins on the ends and the red K. ... >>8- Red gun The SHORTED one ... >>11- blue gun ... I dont know G1 from G2 with them being labeled for me. ...
    (sci.electronics.repair)