Re: Stripping 40 AWG/45 SWG or finer magnet wire/enamelled copper wire?

N_Cook wrote:

So what is the best mechanical technique?

Have you actually tried to solder the wire without removing the enamel first?

Ron
.

Relevant Pages

  • Re: REMOVING ENAMEL COATING
    ... product displays and stocks at NON-ham electronics stores. ... wire has ALWAYS been the same to this day. ... Amateurs who are in the know use solder ... this "Southgate Radio" you keep mentioning doesn't ...
    (rec.radio.amateur.homebrew)
  • Re: Gottlieb System 1 Adventures with Sinbad
    ... hole to thread the wire through then solder. ... Trying to figure out what connectors you're talking about though, ...
    (rec.games.pinball)
  • Re: soldering perfboard
    ... you can place a bare wire on the under side of the perf ... critical, sure, solder them directly to the perf board. ... caps near to digital IC's to have the power rails under the DIP body. ... -- 5 holes per just like a protoboard, ...
    (sci.electronics.basics)
  • Re: Pickup installations
    ... thin rosin core solder. ... the pickguard screws and the pickup install/height screws. ... or cloth) to expose the bare wire strands to solder in there. ... I agree about the fuzz stuff. ...
    (alt.guitar)
  • Re: Desoldering chips
    ... getting the solder to flow to the wires - it would rather stick to ... make sure to melt the tin on the wire ... don't try to transfer it from the soldering iron to ... This is to provide good heat transfer. ...
    (comp.sys.cbm)