Re: Is there a non-permanent way of attaching wires?

daviddschool wrote:

I am looking for a non-soldering way of attaching flexible wire to a
LED leg - I know I could wrap it, but I think it time it might come
loose or the connection might not be the greatest - has anyone come
out with a product that will work so if I wanted to change the LED, it
would be easy to attach the new one without soldering it?

Thanks in advance,

Most of the older computers had leds plugged into connectors !
If you are in the UK I can send you some.

--
Best Regards:
Baron.
.

Relevant Pages

  • Re: Running, Steaming and Anchor lites
    ... into existing bayonet or bipin lampholders. ... I'm not trying to dissuade you from getting new nav lights. ... On the other hand if the bad connection is ... Someone else thought I could replace just the bulbs with LEDs. ...
    (rec.boats.cruising)
  • Re: Digital Current Control for LED array
    ... >>> voltage across them assuming they are of the same type. ... >>light output levels due to differences in phosphor coating (for white ... >>LEDs) thermal conductivity of the package and other physical ... A parallel connection sets the Voltage of each LED as fixed and NOT the current. ...
    (sci.electronics.design)
  • Troubleshooting connection loss (novice question)
    ... My DSL connection usually runs well, but about once every seven to ten days I lose my Internet connection. ... I've not been able to regain my Internet connection without a reboot. ... NIC LEDs: NIC is Intel Pro/100 M with two LEDs. ... When I have an Internet connection, the eth0 monitor shows continuous activity, even when I'm not accessing anything. ...
    (comp.os.linux.networking)
  • Re: Troubleshooting connection loss (novice question)
    ... My DSL connection usually runs well, ... I've not been able to regain my Internet ... NIC LEDs: NIC is Intel Pro/100 M with two LEDs. ... The eth0 monitor shows zero activity. ...
    (comp.os.linux.networking)
  • Re: Current-driving a powerful IR-illuminator array
    ... support continous currents of 100 mA and peak currents of up to 500 mA. ... I once used the following approach to drive 25 IR leds in sync with a camera ... to make the common connection at ground. ...
    (sci.electronics.design)