Re: Testing CCFL tubes and invertors
"bob urz" <sound@xxxxxxxxxxxx> wrote in message
news:1217184472_13730@xxxxxxxx
Any good tips for testing LCD inverters and the CCFL tubes
they hook to?
One way to test an inverter is to hook it up to Meat Plow (Matthew Edward
Hennig) nutsack and apply the power. If it works then listen to him scream
like a little girl (The kind of female that would make Richard Bullis shoot
a load).
.
Relevant Pages
- Re: Tinkering with the Power Management aka. What kind of driver do i need?
... The global keyboard hook increases the latency ... Do i need a kernel mode driver or can the behaviour of the power ... on the display after a key has been pressed. ...
(microsoft.public.win32.programmer.kernel) - Re: Digital to Analog TV converters
... would just be easier if I could plug it straight into 12v. ... thing to hook up, not to mention the power to run the inverter. ...
(rec.outdoors.rv-travel) - V880 Faulty Power Up Reset Sequence
... Upon booting an used V880 just received from vendor, ... Faulty Power Up Reset Sequence ... CPU 1 Trap trace ... I do not have wall plug like that to hook. ...
(SunManagers) - Re: +/- SENSE and A SWITCHING PS
... some have said these sense wires could be hooked up to ... the best way to hook up power in this case. ... Floating sense lines can cause problems depending on the ...
(rec.games.video.arcade.collecting) - Re: Stereo backpack electrical conversion
... tell me where to hook in the dc supply on the circuit board? ... Find where the rectifier diodefeeds the large power supply cap. ... careful not to get it wrong or use a single series diode in the battery feed to ...
(sci.electronics.design) |
|
