Coiled (Rectractile) Coax

Hello, all. I would like to replace the probe cable on a portable Geiger
(GM) counter with a shielded, coiled coaxial cable with male BNC
connectors on both ends. Currently I'm using a straight length of RG-58
but the GM counter originally was supplied with a coiled cable (the outer
rubber (?) covering eventually split in many places). A coiled cable is
no longer available from the manufacturer, Eberline, but I did locate one
from Ludlum (another manufacturer of GM instruments) for about $80.00.
Does anyone know of any other sources of coiled, connectorized cable as a
less expensive alternative? The cable should be shielded and capable of
withstanding at least 1000 VDC (audio/mic cable will not suffice). Thanks
for your time and comment. Sincerely,

John Wood (Code 5550) e-mail: wood@xxxxxxxxxxxxxxxx
Naval Research Laboratory
4555 Overlook Avenue, SW
Washington, DC 20375-5337
.

Relevant Pages

  • Re: Homebrew wifi antenna coax adapters
    ... SMA coax connectors. ... and antenna together). ... manufacturer for Part 15 certification are no longer valid. ... FCC's Part 15 ERP rules for WiFi will allow. ...
    (rec.radio.amateur.antenna)
  • Re: Should this be offensive?
    ... > connectors, ... > using metric measurements. ... cable which is made by an oriental manufacturer. ...
    (sci.lang.japan)
  • Identifying a Connector ...
    ... Does anyone know for sure who the manufacturer is, ... cut into one side of the box, and which take a plug with a polarising bump ... set the same distance apart as the recess. ... to be useable with existing connectors. ...
    (sci.electronics.repair)
  • Re: Are there two kinds of modem cable?
    ... connectors - that is if you can see the colours - or alternatively use a ... continuity tester. ... You may be able to establish which one you need from the manufacturer of the ... Prev by Date: ...
    (uk.telecom)