Re: Great Mystery Compaq Presario 1200XL Laptop

On Thu, 05 Mar 2009 11:47:44 -0800, David Nebenzahl
<nobody@xxxxxxxxxxxxxxx> wrote:

On 3/5/2009 5:46 AM PeterD spake thus:

On Wed, 04 Mar 2009 17:09:10 -0800, David Nebenzahl
<nobody@xxxxxxxxxxxxxxx> wrote:

On 3/4/2009 4:46 AM Ken spake thus:

Brad wrote:

I have a Compaq Presario 1200XL laptop computer that one day, would
not power up. I tried another power supply, replaced a dead
RTC/cmos battery, etc. I removed the RTC battery, main battery, and
put it away. A month later, I decided to try it again. It powered
up! Everything seemed just fine, but it only lasted for a couple
days before it happened again. Again, I put it away. A month or so
later, it powered up and again everything seemed just fine. I
downloaded ROM Paq SP15611 and I "flashed" the bios. About a day
and 1/2 later, the laptop "died". Now it won't boot up. Again after
a long rest period, it came back to "life", but for how long? Note:
It won't power up after a week's "rest", but it will power up after
a longer rest such as a month!

If it were my computer the first thing I would do is clean the
contacts of the RAM. It sounds a lot like a bad connection and the
RAM is essential to it booting to even a bios screen for most
computers.

True, but it's hard to see how that would explain the bizarre behavior
the O.P. reported (what, do the memory chips magically unseat
themselves, then reseat themselves in the interval?).

Easy to explain: the notebook has a (large) capacitor that is across
the backup battery so that when that battery is replaced, the settings
are not lost. He removes the backup battery, then in the (couple of
weeks) time the capacitor finally discharges and the configuration
settings are lost, and the computer can reboot.

I don't get it; how would the settings not being lost lead to the
computer not being bootable? This would seem to defeat the whole purpose
of nonvolatile configuration settings, unless I'm missing something
obvious in your reply.

Corrupted hard drive data... I've seen it happen where it would only
boot if the computer NVRAM data was set to factory specs (telling the
BIOS to find out what the drive is). Very rare... But then again, the
OP's problem seems a bit unusual, too! <g>
.

Relevant Pages

  • What I learned from Hurricane Charley
    ... Since we never lost power, I'm not sure about the level of our food and ... Since emergency shelter in the county in which I work (and to which I must ... In the late spring we had pulled out our battery operated drill and used it ... we could safely handle the panels without injury to our hands. ...
    (misc.survivalism)
  • Re: After recent XP Update, Computer Now Turning on Automatically
    ... You can replace the battery yourself. ... As for the BIOS settings, "Stay Off" simply tells the PC to remain powered ... what it was doing when the power was removed. ... I have to reset the clock to the current date. ...
    (microsoft.public.windowsxp.general)
  • Re: UPS waveform question for SUN servers
    ... O.K. The pure sine wave is better for systems with input ... The SB-1K and SB-2K use the same power supply. ... this UPS has caused more trouble than ... it has alleviated - with the battery sometimes discharging for no ...
    (comp.sys.sun.hardware)
  • Re: Battery Changing
    ... | If the on-board battery dies, you lose your CMOS settings, right? ... If you have a fairly modern system using at least an ATX power supply, ... As others have suggested, it is easy to back up the CMOS settings, and the ...
    (microsoft.public.windowsxp.basics)
  • Re: Redox batteries
    ... When you say that charging will use a fraction of the power of the generator because most of it is used by the propulsion, you are right when you consider riding at nominal speed. ... In this case, what I need is having the generator run for one hour at full power, then quietly ride using the batteries only for ten hours. ... You do not need to modify the charger itself - it bases lowering the current on voltage only, and "relaxing" will make sure that battery voltage will not go high enough to start throttling down the current. ... it does not matter how to charge it as long as you do not cause ...
    (sci.chem.electrochem.battery)