Re: How to develop a basic robot

From: Julie (julie_at_nospam.com)
Date: 06/28/04 

Date: Sun, 27 Jun 2004 23:09:57 -0700

bcpr wrote:
>
> Could anyone tell me some info to develop a basic robot.....& is
> it possible to control a stepper motor through parallel port
>
> Posted Via Usenet.com Premium Usenet Newsgroup Services
> ----------------------------------------------------------
> ** SPEED ** RETENTION ** COMPLETION ** ANONYMITY **
> ----------------------------------------------------------
> http://www.usenet.com
>
> ----== Posted via Newsfeed.Com - Unlimited-Uncensored-Secure Usenet News==----
> http://www.newsfeed.com The #1 Newsgroup Service in the World! >100,000 Newsgroups
> ---= 19 East/West-Coast Specialized Servers - Total Privacy via Encryption =---

Look at BASIC STAMP kits -- a good place to start from the ground up.

Relevant Pages

  • Re: xpc stepper motor
    ... toolbox via parallel port. ... Now i would like use xPC to ... control that computer in order to control the stepper motor. ...
    (comp.soft-sys.matlab)
  • writing to parallel port
    ... at certain pins that go to a stepper motor driver.  ... motor control in the stepper motor driver.  Also, ... Basically i need to know how to set up my parallel port on my labtop in labView 7.1? ...
    (comp.lang.labview)
  • How to develop a basic robot
    ... it possible to control a stepper motor through parallel port ... Posted Via Usenet.com Premium Usenet Newsgroup Services ...
    (sci.electronics)
  • xpc stepper motor
    ... toolbox via parallel port. ... Now i would like use xPC to ... control that computer in order to control the stepper motor. ...
    (comp.soft-sys.matlab)
  • Re: How to develop a basic robot
    ... bcpr wrote: ... > it possible to control a stepper motor through parallel port ... Q2 - yes, you can control almost everything from the PP, if the speed ...
    (sci.electronics)