Re: Speed of propagation

From: GPG (peg_at_slingshot.co.nz)
Date: 07/23/04


Date: 23 Jul 2004 04:24:09 -0700


"Bob" <techxrwb@ix.netcom.com> wrote in message news:<B7%Lc.8488$iK.5355@newsread2.news.atl.earthlink.net>...
> Is there a procedure for calculating the propagation speed of an electrical
> signal over wire given the type of wire and its dimensions? If not is there
> some rule of thumb for the speed?
>
> Bob

Google "velocity factor"



Relevant Pages

  • Re: Standing rigging - stress calculations
    ... would react at the top of the mast ... ... can roll unimpeded) and by pulling horizontally (or calculating the ... MEASURE the stress/strain in the wire (cap shrouds). ...
    (rec.boats.cruising)
  • Re: Speed of propagation
    ... >> Is there a procedure for calculating the propagation speed of an electrical ... >> signal over wire given the type of wire and its dimensions? ... About two-thirds the speed of light. ...
    (sci.electronics)
  • Speed of propagation
    ... Is there a procedure for calculating the propagation speed of an electrical ... signal over wire given the type of wire and its dimensions? ... Bob ...
    (sci.electronics)
  • Re: Speed of propagation
    ... >> Is there a procedure for calculating the propagation speed of an electrical ... >> signal over wire given the type of wire and its dimensions? ... > between front edge of pulse is the time delay in wire, ...
    (sci.electronics)
  • Re: AMOS question (Ping Jeff)
    ... A 3/16 ABS ... Not stiff enough. ... change in reflector dimensions. ... I assume this is to support the wire relative to ...
    (alt.internet.wireless)

Quantcast