what connector size
Got several unmarked coax lines of different OD sizes.
I need to use some twist on bnc end connectors, as my application requires
occasional need to remove the connectors to pull the cables though a small
hole, then later reinstall the bnc ends.
The bnc twist on connectors come in several sizes.
Is there a chart or table that will tell me what coax type I likely have by
the OD measurement?
Do I need to trim a short length off the coax cable end each time I reuse
the bnc twist on fittings?
.
Relevant Pages
- Re: "F" Connectors ?
... Expect to go with F connectors on the coax as they are so readily available already made up, ... I plan on RG6U, Quad Shield, probably ... Just as a sidelight, I also have a sw set, and have all N and BNC on my PAR antenna to the sw set run, though. ...
(rec.radio.amateur.antenna) - Coax Cable Question (Receiving Application Only)
... A few years ago I ran coax from the attic Scantenna down to a downstairs ... room for my GRE Scanner. ... coax I use as long as the connectors are, e.g., BNC. ...
(rec.radio.amateur.antenna) - Re: Balanced connections on domestic equipment.
... tail the coax to join to the socket. ... You don't have to do that with the BNC plugs I recall. ... This is also true for F connectors. ... By implication, it is in the model designation, which may be stamped on the ...
(uk.rec.audio) - Re: Coax Connectors Question
... antennas, including HF receivers and Scanners, with multiple antennas. ... a simple plug panel using, I imagine, BNC connectors and coax. ... Any better coax connectors for this kind of patch panel usage in your ... military patch panels. ...
(rec.radio.amateur.antenna) - Re: A word
... and we had at least two sources of BNC connectors; ... >good ones needed a real crimper, while the bad ones were meant for ... >toolless installation and were the usual cause of broken segments. ... BNC was, and still is, used for connections between frequency generators, ...
(alt.sysadmin.recovery) |
|
