MOSFET Failure Problem

I am attempting to drive 8 logic-level MOSFETs (IRLR2905) with an 8-bit bus
switch (FST3244). I have a 300 Ohm resistor in series with the gate of each
MOSFET. Fast switching time isn't a necessity. I also have a 30V Zener
diode connected across the drain-source to handle reverse transients. The
MOSFETs are being used as low-side switches for 12V automotive fuel
injectors (solenoids). I have 4 of these particular circuits built and am
having trouble with all of the MOSFETs failing short-circuit. The first
circuit worked for a little while, the second has yet to fail, and the third
and fourth failed immediately after power-up.

The MOSFETs have a maximum Vds rating of 55V (I am only using 12V) and a Id
20A (I am only using 1.2A). The bus switch has a logic-level output (5V).
I can't see how I am stressing these parts. Any ideas of what may be
happening?


.

Relevant Pages

  • Re: efficient low-voltage ac/dc conversion for bicycle battery charger
    ... except that I was a bit fast and forgot the high voltage ... When the peak voltage is over the battery one, then the MOSFETs intrinsic ... diodes make a simple bridge with the schottkies and there's no mean to ... > feeble to properly switch the MOSFETs with a decent risetime). ...
    (sci.electronics.design)
  • Re: Stepper motor control
    ... If you switch the MOSFETs ... you may want to use a much lower frequency - the motor ... The very high frequency components will - of couse - see the motor ...
    (sci.electronics.design)
  • Re: MOSFET Failure Problem
    ... 8-bit bus switch. ... I have 4 of these particular circuits built and am having trouble with all of the MOSFETs failing short-circuit. ... turn-on and turn-off times. ... Use a diode with series resistor no less than the solenoid coil resistance, and no more than 10 times the solenoid coil resistance. ...
    (sci.electronics)
  • Re: MOSFET transient dissipation
    ... I intend to use IRFZ44N MOSFETs to switch ... since incandescent lamps draw a high turn-on surge ... I wondered if it's advisable to bolt the MOSFETs ...
    (sci.electronics.design)
  • Re: MOSFET transient dissipation
    ... I intend to use IRFZ44N MOSFETs to switch ... since incandescent lamps draw a high turn-on surge ... I wondered if it's advisable to bolt the MOSFETs on ...
    (sci.electronics.design)