Re: USB not working with NG TOPO


ahhh, that was it.
changed the connection type back to Serial port, confirmed/selected the
proper COM port (as shown in Device manager) and viola!! ...it works now!

Thanks Jack for pointing me in the right direction!


"Jack Erbes" <jackerbes@xxxxxxxxxxxx> wrote in message
news:UKGdnSLZP-5I8o3ZnZ2dnUVZ_tednZ2d@xxxxxxxxxxxxxxx

When the serial to USB converter is PNP'd by the system, it creates a
virtual COM port for it. So your application needs to connect with that
COM port, it is not connecting with a USB port.



.

Relevant Pages

  • Re: roZetta Status
    ... roZetta firmware is written in ZBasic and uses the ZX-40 from Elba, ... There is one main highspeed RS232 level serial port which interfaces ... with the TW523 as the ZX-40's interrupts are sluggish about 3% of the time. ...
    (comp.home.automation)
  • Re: How to Disable Ethernet
    ... you can use the serial port as an alternative method of getting debug. ... can disable KITL debugging and just read all of the messages that come out. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: how to access the serial port exported functions in my applica
    ... you cannot access a serial port by loading the serial ... driver DLL into your application via LoadLibrary. ... I am trying to load com16550.dll using ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Nokia LD-3W Bluetooth GPS/Samsung NC-10 netbook
    ... The little netbook is fully Bluetooth enabled. ... Tonight I got curious as to how the Nokia LD-3W bluetooth GPS would ... It created COM9 and used Bluetooth Serial Port protocol, ...
    (rec.boats.cruising)
  • Re: Data transfer from CM436 with Ciclotour
    ... The driver for a USB converter should then have a virtual serial port COM# ... surprised if it wasn't assigned COM1, ...
    (rec.bicycles.tech)