Re: Low cost material
- From: dmartin@xxxxxxxxxxx
- Date: 9 Jun 2005 04:02:50 -0700
How about a thin aluminum *** like a cookie ***? Punch indentations
in it to form the pockets you need. A muffin tin?
Fiberglass/epoxy; you want a material with a softening temperature
considerably higher than 200F to prevent permanent deformation.
Or a thick aluminum plate. The heat capacity of a particular volume of
AL is only about twice that of the same volume of PMMA.
Dave
.
- References:
- Low cost material
- From: signaturefactory
- Low cost material
- Prev by Date: Material With High Elastic Energy Density?
- Next by Date: inherent cost for photo-voltaics?
- Previous by thread: Re: Low cost material
- Next by thread: Re: Low cost material
- Index(es):
