Re: When radius point is not accessible.
From: Narasimham G.L. (mathma18_at_hotmail.com)
Date: 08/23/04
- Next message: José Carlos Santos: "Re: Question Regard Cardinality and Its Implications"
- Previous message: Marcel Martin: "Re: Partial difference equation, primes"
- In reply to: Mr.Grubb: "When radius point is not accessible."
- Messages sorted by: [ date ] [ thread ]
Date: 22 Aug 2004 23:33:43 -0700
I suppose you need a full circle. First mark four points N,S,E,W of
column correctly. If possible,weld a very small 1/8" steel hook or
drill a tiny hole at center of H-column. Draw arc of circle, as much
as it is possible not obstructed by flange of H-sectioned beam. (They
can be cut/filled up later on).For the remaining part transfer from
the already drawn circle using cardboard or canvas or thick paper.
Mr.Grubb <3f8s@voicenet.com> wrote in message news:<qqjei0ppo3pgt69o09ub4tem2991ka2vbk@4ax.com>...
> I work construction as a carpenter and need to layout interior
> partition walls on a curve. More specifically, this curve is a 25'-0"
> radius. The problem is that the "focus" point or pivot point to swing
> the
> radius is not accessible to me because it's position is located dead
> center of an existing 10" H-column.
> What is the best and most efficient way to proceed while trying to
> maintain the integrity of the 25' radius?
>
> Thank you
> Chris Grubb
- Next message: José Carlos Santos: "Re: Question Regard Cardinality and Its Implications"
- Previous message: Marcel Martin: "Re: Partial difference equation, primes"
- In reply to: Mr.Grubb: "When radius point is not accessible."
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
