Alumina Etchant

From: Ankur Aggarwal (gtg712c_at_prism.gatech.edu)
Date: 06/24/04


Date: 24 Jun 2004 20:40:54 GMT


Hi:

Can anyone suggest me an etchant for Alumina that does not have any/much
effect on copper?

Thanks

Ankur



Relevant Pages

  • Re: Thermal Insulators.
    ... I am investigating insulation between a heat sink and heat generator. ... I intend on epoxying copper to copper, and copper to alumina, so I need aome solid material. ...
    (sci.electronics.design)
  • Re: PCBs in UHV
    ... the diffusion situation gets complex if the board is partially ... It sounds like you don't like the alumina substrate idea; ... steel circuit board ... Porcelainized steel, with additive copper wiring, can ...
    (sci.electronics.design)
  • Re: electro plating
    ... >>ozone, where would you recommend I go to find out about this ... To make matters worse, the alumina ... copper wire brush to imbed a layer of seed copper. ...
    (sci.chem)
  • Re: Home PCB (Was: Dead Bug)
    ... You're dumping a residual amount of ferric ... plus a bunch of copper chloride. ... into the exhausted etchant. ... solution will precipitate out as an insoluble solid. ...
    (rec.radio.amateur.homebrew)
  • Re: Home PCB (Was: Dead Bug)
    ... You're dumping a residual amount of ferric ... plus a bunch of copper chloride. ... into the exhausted etchant. ... solution will precipitate out as an insoluble solid. ...
    (rec.radio.amateur.homebrew)