Re: need to pass laser through motor axis

rmigliac_at_yahoo.com
Date: 09/27/04 

Date: 26 Sep 2004 20:33:30 -0700

Not sure of the question here. The size aperture implies a shaft
diameter of 12 mm or more. You may want to consider a conventional
motor connected to the hollow shaft device with a belt or gear.

Relevant Pages

  • Re: Aligning the tailstock?
    ... an internal square drive socket for a flexible drive shaft at the ... The 'chuck' is really a conical bit at the end of the inner ... the same diameter for neatness). ... Adjust tailstock until the diameters are the same. ...
    (uk.rec.models.engineering)
  • Re: Follow rest
    ... A 3 foot 17mm piece of drill rod sounds like a good candidate. ... 4140 shaft to a diameter ... Aloris CXA tool post? ... 2-4 thou and then grind to the final diameter ...
    (rec.crafts.metalworking)
  • Re: need to pass laser through motor axis
    ... The size aperture implies a shaft ... > diameter of 12 mm or more. ... > motor connected to the hollow shaft device with a belt or gear. ... Is there a 3600rpm synchronous motor that will do ...
    (sci.optics)
  • Re: Follow rest
    ... 4140 shaft to a diameter ... Aloris CXA tool post? ... 2-4 thou and then grind to the final diameter ... 4140 shafting or ground stock in metric diameters. ...
    (rec.crafts.metalworking)
  • Re: Good high speed shaft material?
    ... 1/4" diameter with a keyway and threads on one end to hold a ... gear. ... You may be encountering "shaft whirl" which causes the shaft to ...
    (rec.crafts.metalworking)