Re: SP FCBar info

"Ilya Eigenbrot" <ilya@xxxxxxxxxxxxx> writes:

> The fibres were probably run with caps on, the metal of the tips was badly
> discoloured and the coating severely fried - the only solvent that may have
> helped would've been hydroflouric acid!

So the damage was to the SMA-end, or both ends?

> And I may not have made myself clear - the back reflection has destroyed -
> beyond any hope of repair - the diode bars.

No, I understood that! :( :)

> I would be interested in getting hold of replacement fibres with 0.5mm
> spacing (for 40W 19-element diode bars)

Unfortunately, the only fibers I have are for 0.650 mm I think.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.
.