Re: How to make two laser beams coaxial ?



Ahgustovy Hugharz wrote:
I have a couple of IR, red and green laser diodes. Experiments with red and green lasers are relaively easy as they are visible.
Can you recommend any simple, practical, method (I am hobbiest with limited budget) to make both IR and red laser beams coaxials ei.alight both the IR and the red laser beams in such a way that IR laser spot always (even at long distances) on the same position where the red laser spot is ?

If I can make them coaxial then I can turn on the red laser, find it spot and switch it off and turn on the IR laser on for IR laser experiments.


IR can be seen on i.e. displays of digital cameras (no special camera is required). Sometimes this is used to check if an IR remote control still functions. Maybe that's a solution?
.



Relevant Pages

  • Hey kids.....
    ... It doesn't seem that long since a club laser was typically an argon unit with a water cooled head. ... Now with DPSS greens and surprisingly high power "normal" red lasers the cost of a scanning club laser has crashed to very affordable levels. ... It's rated 50mW but because green lasers use a much higher power infra red diode to stimulate a crystal to lase in a different wavelength, then double it's output frequency with another crystal the power dissipation tends to be pretty high compared to a conventional red laser diode. ... At the back of the unit is a transformer for the fan, steppers and control card, while the lasers themselves are surprisingly controlled by two independent mains powered switch mode supplies stacked on top of each other. ...
    (sci.engr.lighting)
  • Re: How to build an ultra high speed photo detector? (for detecting red laser pulse)
    ... where we are sending out a pulse of light with a red laser, ... Timing the signal is fairly ... We are using a high speed laser driver chip which gives us ... approximately 40ps rise and fall times on the laser pulse. ...
    (sci.electronics.design)
  • Re: Wavelength and power measurement of laser pointer
    ... IR) wavelengths will be *roughly* in inverse ratio to wavelengths. ... Green laser pointers (pointers, not some green diodes that you might ... My understanding is red laser diodes may have wavelengths from 670 nm ...
    (sci.optics)
  • Re: Reflectance setup
    ... for an optical reflectance system? ... I plan to use a red laser, ... I need a detector and a module ... since the detector and laser will be colinear. ...
    (sci.optics)
  • Re: Red or green laser?
    ... > Question on which laser to buy. ... > used when pointing out objects in the night sky. ... If a $50 green laser does the ... I can buy a red laser anywhere it seems ...
    (sci.astro.amateur)