Re: PFN Vacuum Relay
- From: Sam Goldwasser <sam@xxxxxxxxxxxxxxxxxx>
- Date: 23 Jun 2007 19:24:29 -0400
Will <mysweeps123@xxxxxxxxxxx> writes:
On my PFN I found that one of the lugs on the low side of the vacuum
relay was broken, cracked where it enters the metal case. I have
ordered another PFN at this point because the only replacements I
could find cost around $100 on eBay and the PFN is much less. Because
they do cost do much, has anyone ever repaired one that was broken in
a similar spot?
Remove the vacuum relay, leave a bleeder in place permanently.
There is a good chance the replacement PFN will also have a bad relay.
--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html
Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
.
- References:
- PFN Vacuum Relay
- From: Will
- PFN Vacuum Relay
- Prev by Date: Firing SSY1 trigger
- Next by Date: Re: Firing SSY1 trigger
- Previous by thread: PFN Vacuum Relay
- Next by thread: Firing SSY1 trigger
- Index(es):
Relevant Pages
|
|
