Re: Magnifying a distant image



"archiees@xxxxxxxxx" <archiees@xxxxxxxxx> writes:
Hi Guys.
I have a 2 inch I.D. , 2 ft long tube which sits inside a big dewar.
At the bottom of this tube there is a 24 pin connector which has pins
made out of gold standing out. I insert a long lead with a
corresponding socket at the bottom and hence it makes connection.
Somehow the pins are not making proper connection to the socket.
Now the problem we have is that we think there is something stuck
between the pins or a couple of pins are bent, thus avoiding a good
contact. We can see using the flash light the connector down there but
it is very hard to make out if any of the pins are bent.
I feel some sort of magnifying glass which will enable us to see the
pins clearly to find out the cause of the problem. If there is
something i can buy online or from a store would be best.
I am an electrical engineer with minimal optics knowledge, so please
excuse my ignorance.

Start with a small monocular telescope, something like 6-8 power and
20-30 mm objective diameter. This is intended to focus at infinity, but
it won't focus at 24 inches unless it's a "short focus" model. To make
it focus closer, you need to give it glasses. With a +1 diopter lens
mounted on the front of the monocular, it will focus between 1 m (39
inches) and somewhat closer. A 1.5 diopter lens puts the far focus
limit at about 26 inches (0.67 m), so anything between about 1 and 1.5
diopters will work. You'll need to physically move the telescope closer
and further away from the subject until it focuses.

Now, where to get a 1-1.5 diopter lens? Photo stores carry +1D lenses
as closeup lenses. Or just get a pair of drugstore reading glasses with
+1 or +1.5 strength and pop one lens out.

Dave
.



Relevant Pages

  • Re: changing the fan cooler on my video card
    ... In other words, the labels that you can read what the connector says are pointed inwards on the inside pins and the connectors on the outside closest to the edge of the mobo, those labels are pointing towards outer most edge. ... as you can throw off the color purity with magnets nearby. ... The Azalia has plug sensing signals, which is the difference from AC'97. ...
    (microsoft.public.windowsxp.hardware)
  • Re: GPS problem
    ... It should show continuity on each line/pin. ... There are only 4 pins on the Garmin unit. ... and there is NO connector in the cable. ... >> solid enough without a screw in place, and it looks like a fairly small ...
    (microsoft.public.pocketpc)
  • Re: Burnt ATX Connectors on ASUS Motherboard
    ... I removed the 5 volt pins on the mobo, ... I contacted Molex The manufacturer of the Connector, ... PSU Nylon shell - $1.12 for a 20 pin shell. ... are rated for 6 amps each, on the main power connector. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: pins, cables
    ... pins on MIDI ports, D15 game ports, D25 printer ports, etc. ... pins and sockets are generally described as having mating ... Pins and sockets are available loose from any of the major connector ... to those available using solder. ...
    (sci.electronics.misc)
  • Re: TECH: JL locks up
    ... Because you say this happens on both left and right flippers, ... I think it was the particular way the board sat in the support pins ... / clean pins and push wires firmly into connector - power and MPU) ...
    (rec.games.pinball)