Is it possible to make holes of 2um diameter into a AgClBr fiber? Could
you sugggest me an article where I can find how to do that?
Laser drilling can make holes that small, but the tolerance may only be
about +/- 40% of the hole diameter. Check out www.lenoxlaser.com for one
provider of laser hole drilling. Another possibility is focused ion beam
(FIB) drilling. Search the Internet for companies that use their FIBs to
modify integrated circuits.
Re: Mystery tool ... the holes then used to show what material to remove, ... drilling or profiling rims.... inside of a rim blank. ... to a profile cutter) or has stops (for drilling holes at intervals). ... (rec.bicycles.tech)
Re: Mystery tool ... the holes then used to show what material to remove, ... inside of a rim blank. ... to a profile cutter) or has stops (for drilling holes at intervals). ... onto the carriage of a lathe with a spoke hole sized drill bit in the ... (rec.bicycles.tech)
Re: Drilling lubrication ... More recently I have been just applying Rapid Tap from time ... steel under it wanted oil and the tap received fancy tapping fluid. ... The rest of the holes all got the tapping fluid for drilling as well. ... (rec.crafts.metalworking)
Re: I want my unicycle as light as possible ... legs for the frame, with 0.002" wall thickness. ... Just two curved tubes.... It's designed around drilling.... If drilling holes helped so much, ... (rec.sport.unicycling)
Re: Water on positive battery terminal? ... so drilling one or more single holes did not cause a problem. ... My act of taking the drill again and drilling a hole right next ... Sure, if the plate is not too thick, and there is no reason for it to be. ... (rec.autos.makers.mazda.miata)
