Re: Fiberscope Bending Damage Image
- From: Sam Goldwasser <sam@xxxxxxxxxxxxxxxxxxxx>
- Date: 17 Nov 2007 19:13:59 -0500
Phil Hobbs <pcdh@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> writes:
Mu wrote:
Hi, What is the appearance in the image of a fiberscope,
borescope or endoscope if there is a bending damage
where the cable is bend tighter than the allowered bending
radius. What are you supposed to see in the image?
Has anyone looked thru one? Thanks.
Mu
Probably darkness on the side corresponding to the inside of the bend.
There's likely little correlation between location in the fiber bundle and
image pixel location except near the ends though.
--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html
Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
.
- Follow-Ups:
- Re: Fiberscope Bending Damage Image
- From: Phil Hobbs
- Re: Fiberscope Bending Damage Image
- References:
- Fiberscope Bending Damage Image
- From: Mu
- Re: Fiberscope Bending Damage Image
- From: Phil Hobbs
- Fiberscope Bending Damage Image
- Prev by Date: Re: Fiberscope Bending Damage Image
- Next by Date: Re: Fiberscope Bending Damage Image
- Previous by thread: Re: Fiberscope Bending Damage Image
- Next by thread: Re: Fiberscope Bending Damage Image
- Index(es):
Relevant Pages
|