Re: My mistake on Time Dilation?

From: Uncle Al (UncleAl0_at_hate.spam.net)
Date: 02/11/05 

Date: Fri, 11 Feb 2005 10:25:43 -0800

guskz@hotmail.com wrote:
>
> Sorry,
>
> One can get lost when it comes to perspectives and observation, the end
> fact they MUST ACCELERATE (for their distance increases considerably
> with time) to compare each others values and by then the clocks would
> have been re-modified????
[snip]

Absolutely not. The triplets experiment has no clock acceleration at
all. Only inertial velocity is required. The clock that passes
through the most space records the least time on local compairison.

http://sheol.org/throopw/sr-twin-01.html

The clock that goes forward and then backwards travels more undeniable
from any reference frame. The same is true for somebody in a circular
orbit hwerein the non-inertial reference frame ages more slowly.

The ratio by which the two have aged at the end when they are back
together again is the same in all reference frames:

ratio = sqrt(t^2 - x^2 - y^2 - z^2)/t (with units of c=1)

Acceleration breaks the symmetry of who ages faster. To accomplish
that, the acceleration can occur before the clocks (or the twins)
exist. Only reference frames matter.

Inertial frames with relative *velocities* pursue different paths
through spacetime in Special Relativity. No clock anomaly is apparent
in any of them until clocks are compared (by all being local when you
do it, initial calibration then experiment). Acceleration is
irrelevant in SR to the running of the clocks (as opposed to
Equivalence Principle acceleration in GR). Acceleration is necessary
at some arbitrary time not associated with the experiment itself for
breaking the symmetry of clock observation. Acceleration defines
which reference frame takes what path through spacetime - even if it
occurs when the clocks are *off* (or not even constructed yet, or
destroyed) - so the situation is NOT symmetric. There is a difference
between the reference frame and any clocks in it.

1) Acceleration is an absolute measurement and it does not require a
clock to make the measurement (e.g, simultaneous displacement of three
independent orthogonally cantilevered masses). There is no doubt who
was accelerated even if a clock was not running/existing during
aceleration. Any past accelerated reference frame has a different
mixture of space and time from an unaccelerated frame.

2) Past acceleration is irrelevant to the running of present clocks,
but not to the mixture of space and time in the reference frame that
said clocks measure. This is an important subtlety and the key to the
whole thing. You cannot synchronize clocks except by having them
local. That's what Relativity demands. If they are local at the
start, you can tell who was naughty thereafter without needing a clock
to do the acceleration measurement. Accelerometers are not clocks.

EXAMPLE: We have three identical clocks that are off (a state of not
running, or of not even having been fabricated) and zeroed. Each
clock has/will have a very short toggle jiggger switch sticking out.
We load them (or their parts, or ore and a smelter and a machine shop)
in individual spaceships and set up the experiment.

CLOCK 1: That's our clock. It sits stationary in our inertial
reference frame with a little jigger sticking out. Touch the jigger
and the "off" state becomes "on" or the "on" state becomes "off."
Clock 1 is "off." Or we can build it from parts just before we need
it, and in the "off" state, zeroed.

CLOCK 2: In a spaceship traveling at 0.999c relative to our inertial
frame of reference. Clock 2 is "off." It was built after all
acceleration ceased, and set to zero. It skims past Clock 1 (our
clock), the jiggers touch, both Clocks 1 and 2 are now "on" and
locally synchronized by touching. Elapsed time accumulates in each
one. The situation is NOT symmetric! We know who accelerated to set
up the experiment even if there wasn't a clock present when it
happened.

CLOCK 3: In a spaceship traveling at 0.999c relative to our inertial
frame of reference, but 180 degrees counter in direction to Clock 2.
Clock 3 is zeroed and "off." It was built after all acceleration
ceased, and set to zero.

Some arbitrary time after Clocks 1 and 2 synchronize and turn "on" by
touching, Clocks 2 and 3 brush past each other, touching jiggers.
Clock 2 is now "off," Clock 3 is now "on." Write down the elapsed
time in now "off" Clock 2, then smash the clock with a sledgehammer.
Or melt it down, or toss it over the side. The spaceship with Clock 3
is returning back over the path taken by the spaceship with Clock 2.

CLOCK 1: That's our clock. It sits stationary in our inertial
reference frame with a little jigger sticking out. Clock 3 rushes
past, jiggers touch. Clocks 3 and 1 are now off. All clocks are
off. No clock has accelerated while "on" or even while existing.
Write down elapsed times, smash each clock with a sledgehammer. Or
melt them down, or toss them.

BOTTOM LINE: Get all three slips of paper together... Accelerate as
you need. Or send all the results to all three folks by radio and
never decelerate. All clocks have been smashed, melted, tossed.
Their elapsed times were written down. The numbers on the papers
won't change when you accelerate or broadcast the data.

Acceleration is arguably General Relativity, as we did setting up the
experiment. It is irrelevant to the clocks. No clock is running or
even exists during acceleration. Numbers written on slips of paper
are unaffected by Special or General Relativity. One could as easily
build the clocks from their component parts after setting up the
experiment. No clock exists during acceleration up or down. The
*reference frame* has accelerated in the past, and that changes its
mix of space and time relative to an unaccelerated frame. The clocks
are passive observers in a presently unaccelerated setting.

Finally.... compare elapsed times. Elapsed time #2=#3 (straight line
motion for both traveling clocks, no acceleration!), but elapsed time
#2+#3 does not equal #1, the local stationary reference frame
summation. The sum of #2+#3 elasped time is only about 4.5% that than
of #1's accumulated elapsed time. You have the Twin Paradox (or,
Triplets) without any running clock having been accelerated - or
having even existed during acceleration up or down. 

-- 
Uncle Al
http://www.mazepath.com/uncleal/
 (Toxic URL! Unsafe for children and most mammals)
http://www.mazepath.com/uncleal/qz.pdf

Relevant Pages

  • Re: Van Flandern & Rethinking Relativity?
    ... timing of change in g (two states of change, effectively acceleration in ... will send the particle into a state of frenzy from relative rest. ... There is only one perfect clock and clock timing, ... Two diametrically opposed views within relativity will work together ...
    (sci.physics)
  • Re: Grandfather Clocks and Relativity
    ... this twin Ta because he will be accelerating later. ... clock always read zero, as long as gravitometers at each clock always ... can make the acceleration instantaneous, or the distance L between the ... That's the sense in which the tick rates of moving clocks change in Relativity, and once you're able to appreciate the dichotomy between a clock's tick rate and measurements of a clock's tick rate, those logical dilemmas won't arise. ...
    (sci.physics.relativity)
  • Re: Galileo auf der Kippe
    ... solchen Infrastrukturprojekt wie Galileo? ... Betreiber *allein* mit Gebuehren fuer die Nutzung ...
    (de.sci.raumfahrt)
  • Re: Hafele & Keating, Einstein, Dingle,Cocke, and Scott Murray
    ... emphasise that special relativity purports to describe certain physical ... and the speed of a clock relative to one of these ... >by acceleration for relativistic effects. ... That gravity has ...
    (sci.physics.relativity)
  • Re: Hafele & Keating, Einstein, Dingle,Cocke, and Scott Murray
    ... > emphasise that special relativity purports to describe certain physical ... and the speed of a clock relative to one of these ... >>by acceleration for relativistic effects. ... >>Quite a number of people think that in relativity gravitation is so ...
    (sci.physics.relativity)