Re: How big is the concrete block?



Ya know a cutting tourch without o2 is just a yellow flaim as hot as
gas and air .
Turning on the o2 and its blue 2400 F and will melt steel with the same
amont of fuel.
But hit the o2 boost and the steel is cut ,,wile its cutting turn the lp
off and cut te steel with o2.
Boost gas air in the lpe ( 120 psi compreion heated to 2400 F cuting
mix. )
then try it in super hot steam at 120 psi .

The ice water rocket ( internal combust eng. )
raced a 3 hp honda outboard by using the same motor as the comtrsor at
250 rpm.
It injects 120 psi in the top of the water pipe .
3 inch 30 inch tall. the door valve is closed and the jet valve closed
the pipe is full to the tdc line and at 120 psi when o2 and gas is
injected. 2400 F .
850 psi out the 1 inch jet hole open.
1 second strokes .
1/4 te gas handa used in its 3hp ,,wile Im running 16 hp.
Was not much of a race !!
16 HP vrs 3 hp..
No water pump no piston no crank no internal resistance no machanical
limits.
The injector is good for life.
It will run for life.
It cant over rev , cant eat the rings or burn a hole in piston or snap
the rod , and the engine is smaller easyer and less fuel is hauled
around.
The Hondagot a WHALING on !! with a whale .





.



Relevant Pages

  • Automatic Control of PRESSURE & TIME of gas flow from H tank cylinders
    ... I have a gas cylinder - H Tank (that can hold oxygen, helium, etc... ... 50 psi pressure) that is used for clinical simulation. ... Provide another set of knobs / digital input switches for the LAG ...
    (sci.electronics.basics)
  • Re: Ether Steam Engine ???
    ... 44 inch cylnder 4 inch id. ... The tank can be any sise,,10 gal,,15 gal.. ... You have a tank 3/4 full of water at 500 psi. ...
    (sci.physics)
  • Re: enough psi in a powerwasher for 3 story house cleaning of siding?
    ... while the gas ones are around 2200 psi or higher... ... trying to clean. ... At five feet, there is just a fine mist gently ...
    (alt.home.repair)
  • Re: CO2 evaporator or vaporizer
    ... refrigerated bulk tank and deliver the gas at about 100 psi. ... Does anyone know of a ready supplier of such a device? ... Why do you need to meter the liquid input? ...
    (rec.crafts.metalworking)
  • Re: Air absorbtion by charcoal.
    ... Uncle Al wrote: ... Do the gas molecuses ... Is it seconds or milliseconds for a step change of 2-3 psi? ... The total differential adsorption for a 5 psi pressure swing is of ...
    (sci.materials)