A Play NUke Sequencer



A switch to trigger three actions is to be stated;

A detonation, a ion source pulse and the accelerator control.




exp. accel.
_______
| |
| |
------------------ -----------------------------

|
reference time


A leading edge causes the electric switch for the detonation. A
trailing edge the combined ion source/accelerator trigger?


A large problem is the noise or mistiming as events out of sequence.
A large capacitor must charge to stop noise! or other means of timing
must be considered.


Here is my choice:

0/1 ----------electric io switch1(on STAMP output bus.)

0/2 ----------- electric io switch2(on STAMP bus)


I have decided to try the double output method using the STAMP as the
timing of the closely synchronized events. A five millisencond delay
for switch 2.

So get out the oscilloscope and test the trigger consitency. NOISE is
a problem and computers are held low while add on 555 timers are not.

SO to aleviate noise in design I just use the nicely clamped STAMP.
Small 5V solid state switches are available for the interface.

A primary consideration must be proper function while the explosive
charge is detonating. A shockwave developes and must not reach the
computer before the computer fires the trigger pulse of neutrons.

A simulator would be inorder to fully validate the computer and to
reliably test.

So as you can see the basic control system is fairly easy. Components
such as 5v, 5000 volt, and 150KV will be posted. A single control
computer for all aspects of detonation!!!!!!!!!!!!!!!!!!!!!1


For the several pound explosive charges- FIVE MILLISECONDS DELAY!1
ONLY.

I posted the basic thermonuclear head several years ago, it is no
longer available, this is now a ply nuke, but fully functional.

.



Relevant Pages

  • Re: Fading Lights Unit
    ... and the fade out rate all the same way. ... switch can control it directly, OR, I could turn ... HOWEVER- lets say I trigger the switch, but at 2 sec into it, I ...
    (sci.electronics.design)
  • Re: sparking/electrical problem with Peco points
    ... compromise your operation in order to keep locos away from each other. ... What I then said was that without an isolating section, ... is compromised by the control system. ... on/off using a switch on a control panel. ...
    (uk.rec.models.rail)
  • Re: Hardince HC Chucker -- someone needs help
    ... the bottom of the control box. ... Keep the coolant switch and wire the VFDs aux output to the ... Hardinge parts are available..usually..from Hardinge or scrap ... NRA LOH & Patron Member, Golden Eagle, Patriot's Medal. ...
    (rec.crafts.metalworking)
  • Re: Speech recognition system for Home automation.
    ... simply map to the hard switches, for dual voice/finger control. ... self contained in a voice chip, ... button keypad would need room for 40 voice commands (5 per switch) ... And as much as I like INSTEON (and use it, ...
    (comp.home.automation)
  • Re: Power Button on PWS
    ... > conclude anything from that ther were 6 with a carbon choke on them. ... and it's hard to achieve that with a hard-wired power switch. ... logic for the power control (manual switch, wake-on-LAN, wake-on-modem, ...
    (comp.os.vms)