Re: Electricity questions




"Albert" <albert.xtheunknown0@xxxxxxxxx> wrote in message
news:19c26383-805a-40d2-864f-56a12ac843b7@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi, these are a list of questions I can neither answer using formulas
I've learnt nor from results from experiments I've performed
(directly):

Why wouldn't you get a shock if you were hanging from a live wire
without your feet touching the ground?

Key word: "circuit"


Is it because 'you haven't made a complete circuit for the current to
flow through you?'

You betcha!
However, you'll get a shock (from a very high voltage) as your body
charges to the same potential as the wire, or the reverse can happen.
Walking along the corridor of a Holiday Inn with a nylon carpet
I was getting a shock when I touched the door handle to my room.
I was charging myself with static electricity from the carpet. The trick
was to touch the door with the key.

--
An electric blanket has two heat settings, one HIGH and the other LOW.
Which setting do you think has the greatest resistance? Give reasons
for your answer.

Watts = Volts * Amps.
Amps = Volts / Resistance.

Since Volts is a constant,
Watts is proportional to Amps/Resistance.

Lower resistance, more watts.
more watts, more heat.

--
Suggest a reason why the transformer that you used sometimes made a
buzzing noise.
My transformer had two coils clipped together with an iron core
linking them.

Alternating magnetic field mechanically vibrating the plates/windings.
Small transformers are usually dipped in a resin or plastic to prevent
movement as well as ingress of moisture which can cause corrosion.
Same with electric motor windings.

Do you know that just one turn short-circuited in the winding is fatal
to the transformer or motor?
The shorted turn acts as a secondary winding, a large current flows
in it, it heats up and cooks the insulation on its neighbouring turns
which also short out and you get that noticeable pong of burned
insulation/varnish. Switch off before there is a fire. There is no
recovery, rewind or replace the transformer/motor.
http://www.androcles01.pwp.blueyonder.co.uk/AC/m.gif



.



Relevant Pages

  • Re: Why is VA used instead of Watts?
    ... > transformer would be watts. ... transformer instead of an identical "Watts" rating. ... technically supplying a 0.0 Watt load but sure as hell notices its full ...
    (sci.electronics.basics)
  • Re: CB amps
    ... Either th e tubes ... |>will implode or the power transformer will smoke. ... |periods can be as high as 1000 watts. ... you can get 1000 PEP out of the 6LB6s for a short period. ...
    (rec.radio.cb)
  • Re: Alarm System Transformer
    ... my previous transformer only put out 20 watts. ... the wattage of an AC device. ... likely the VA rating will be exceeded in order to supply the 40W to ...
    (alt.security.alarms)
  • Re: House number sign with wires in it...
    ... bulbs to light up at dusk. ... it's a goddamn low-voltage house number fixture. ... transformer, like a doorbell transformer. ... Working properly two 18 watt bulbs will consume 36 watts per hour; ...
    (alt.home.repair)
  • Re: Everyone got their generator ready?
    ... generator voltage down? ... It may not take much of a shock to cause the linesman to fall. ... only 230 as far as the transformer serving the house. ... linemen face to face and show them the fuses. ...
    (uk.business.agriculture)