Re: sts 120 mission end
On Thu, 08 Nov 2007 08:38:33 GMT, "Brian Gaff"
<briang1@xxxxxxxxxxxxxxxx> wrote:
My gut feeling on this is a burr on
a nut or bolt in fact. You only need a tool to slip at high torque.
....Or an even simpler tool, something along the lines of a car battery
terminal cleaner; just slip it over the bolt, screw it back and forth,
and scour away the burr.
OM
--
]=====================================[
] OMBlog -
http://www.io.com/~o_m/omworld [
] Let's face it: Sometimes you *need* [
] an obnoxious opinion in your day! [
]=====================================[
.
Relevant Pages
- Re: Orion XT6, not able to assemble the base
... think plastic ring on the inside, so I cannot tighten the bolt. ... The nut with a thin plastic ring inside is a nylon lock nut. ... The top baseplate has a hole in the center. ...
(sci.astro.amateur) - Re: MGB Front Wheel Hub
... Remove cotter pin from large nut at top of king pin above the top wishbone. ... If the bush and sleeve are corroded it is probable that the bolt is rotating ... Next move, to remove the stub axle, which was going OK until I got to ... Wnen the puller is tightend up ...
(uk.rec.cars.mg) - Re: lost webpage - using weedwhacker string for "thread locking" - ie nylock
... Normally -- you don't want the string all the way through. ... bolts, and if there is a lot of load on the bolt, you want it to engage ... near the outer side of the nut so you don't weaken the bolt too much. ... The machine jacks will be used to set a sine bar because until I have sets ...
(rec.crafts.metalworking) - Re: Grand Marquis Idler Arm Bolt Loosened?
... The steering was not sloppy until the bolt slipped out of the hole. ... The car handled great before the idler arm became disconnected. ... is one of those castellated nut with cotter pin. ...
(rec.autos.tech) - Re: OT - Torque the Nut or the Bolt?
... wrench and use thetorquewrench on the bolt, or I can hold the bolt ... with a standard wrench and use thetorquewrench on the nut. ... fastener limit,torqueat least 6 to failure, verifying that the results are ... I actually have 2 types of torque to deal with. ...
(alt.home.repair) |
|
