Re: Alignment of microscope optics - how...?

On Feb 10, 12:56 pm, justbeats <steve_be...@xxxxxxxxxxx> wrote:
How does one ensure every component in the light path of a research
microscope is exactly central with respect to the optical axis? What
do you use as the reference to line everything else up against?

The question is prompted by recent efforts to correct a minor niggle
on my Zeiss ICM 405 inverted. The realignment required me to adjust
grubscrews in a the dove-tail mount to shift a component relative to
the centre line. I got stuck in an endless loop where fixing the
niggle introduced other alignment problems (usually vignetting) and
fixing that introduced yet more problems elsewhere. Argh!

I've got it all back where I started, the scope performs great, and
I've decided the niggle is bearable after all - until I know more. I
hope I'm asking the right question. Can anyone point me at more info
on this subject? Thanks in advance...

Cheers
Beats

PS. In case it helps, the specific niggle is with an optovar fitted
under the trinocular head. It delivers a full, unobstructed field of
view at all magnifications but the phase-telescope view is shifted
left of centre. Adjusting the grub screws on the dovetail recentred
the phase telescope image, but then the main (specimen) view is
vignetted with a black crescent around one side. Adjusting the
dovetail on the trinocular head to fix that problem brings the
original niggle back, and leaves the internal photo reticle off centre
(can't see an adjustment for that - although it is on a removeable
slider in the main body of the instrument). Given that EVERYTHING is
on a dovetail - where do you start...?

Beats, what you need you probably can't get. There are several ways
to approach this, what Zeiss did was to use a pre-centered eyepiece
and a dummy objective with a pre-centered target built in. This was
strictly for repair tech and production techs so not a lot of these
were made. However if you had one it was trivial to adjust everything
and then lock it in place. With out one, well, its a lot more
trouble.

Now the interesting point. This wouldn't have done a thing for the
problem you describe. This problem is in the rotary part of the
optovar, actually in the phase centering section. You have to adjust
that, put it back together and check, shampoo, repeat. Don't under
any circumstances change the adjustment screws for the head, you'll
have the problems you described.

Thanks,

Kevin Cunningham
SMS
.

Relevant Pages

  • Re: OT form problem
    ... Small niggle, but you might want to adjust the form layout so that ... all the input boxes line up. ...
    (rec.juggling)
  • Alignment of microscope optics - how...?
    ... The question is prompted by recent efforts to correct a minor niggle ... Adjusting the grub screws on the dovetail recentred ... dovetail on the trinocular head to fix that problem brings the ...
    (sci.techniques.microscopy)
  • Re: Grizzly 8 inch jointer
    ... Haven't had to adjust the beds yet - they came perfectly aligned from ... I picked this one over the slightly cheaper dovetail Grizzly ... Looking to upgrade my Delta 6 inch jointer. ... I had to use shims on the dovetail ways, to get both infeed and outfeed beds ...
    (rec.woodworking)